IIUM Repository

Dry machining of brass using titanium carbonitride (TiCN) coated tool

Mohamed Ariff, Tasnim Firdaus and Kamarudin, Mohd Syahidan and Haron, Mohd Amiruddin (2013) Dry machining of brass using titanium carbonitride (TiCN) coated tool. Applied Mechanics and Materials, 372. pp. 495-500. ISSN 1660-9336

[img] PDF - Published Version
Restricted to Repository staff only

Download (362kB) | Request a copy

Abstract

Dry machining is environmentally friendly, clean and safe to be performed. Regardless of decreasing tool life due to lack of lubricants, choosing dry machining over wet machining may be a wiser choice since the cost of purchasing and disposing the cutting fluids can contribute to a higher cost. Wear rates, tool wear intensities and material removal rates (MRR) of TiCN coated tools using both dry and traditional wet machining on brass were studied with the aim in finding the optimum cutting condition from four different cutting speeds (207, 279, 372 and 498 m/min) with two sets of cutting parameters; depth of cut and feed rate (d = 0.1 mm, f = 0.2 mm/rev and d = 0.2 mm, f = 0.4 mm/rev). Temperatures at the tool-chip interface were measured to analyze the effects of temperature rise during dry machining. Cost analysis on machining cost per piece between dry and wet machining was performed. The optimum cutting condition for wet and dry machining of brass using TiCN coated cutting tool was found to be 498 m/min at d = 0.2 mm, f = 0.4 mm/rev. The tool tip temperature obtained from dry machining did not influence tool wear since the temperature rise is quite similar to the wet machining temperatures. The machining for the dry machining reduced to about 25-76% per piece when compared with wet machining.

Item Type: Article (Journal)
Additional Information: 5202/31460
Uncontrolled Keywords: clean machining, dry machining, wear analysis, tool life, optimum cutting speed, MRR, cost analysis, TiCN coated tools, brass.
Subjects: T Technology > T Technology (General)
T Technology > TS Manufactures > TS200 Metal manufactures. Metalworking
Kulliyyahs/Centres/Divisions/Institutes (Can select more than one option. Press CONTROL button): Kulliyyah of Engineering > Department of Manufacturing and Materials Engineering
Depositing User: Dr. Tasnim Firdaus Ariff
Date Deposited: 29 Aug 2013 10:42
Last Modified: 29 Aug 2013 10:42
URI: http://irep.iium.edu.my/id/eprint/31460

Actions (login required)

View Item View Item

Downloads

Downloads per month over past year