Formulation and optimization of raloxifene loaded nanotransfersomes by response surface methodology for transdermal drug delivery

Mahmood, Syed and Bakhtiar, M. Taher and Mandal, Uttam Kumar (2014) Formulation and optimization of raloxifene loaded nanotransfersomes by response surface methodology for transdermal drug delivery. In: 1st International Conference on Industrial Pharmacy, 16-17 August 2014, Kuantan, Pahang. (Unpublished)

PDF - Published Version Restricted to Repository staff only Download (1MB) | Request a copy

Abstract

Raloxifene HCl belongs to selective estrogen receptor modulators (SERM), structurally similar to estrogen with important effects on reproductive and many non-reproductive tissues. It is highly recommended by medical practitioners for the treatment of breast cancer, osteoporosis, and postmenopausal symptoms. It is mostly administered at a total dose of 60 mg tablet daily. However the major obstacle for the oral delivery of raloxifene is poor systemic exposure with only 2% absolute bioavailability because of its poor solubility in aqueous fluids and extensive first pass metabolism [1, 2]. Transfersome is an ultra-deformable vesicle which is composed of an aqueous core surrounded by a combination of lipid and surfactant. Unlike the conventional liposome, presence of surfactant makes transfersome an ultra-deformable, self- regulating, highly adaptable, and stress responsive complex aggregate [3]. Raloxifene loaded transfersomes were fabricated, optimized and characterized as carrier for transdermal delivery to overcome the poor bioavailabilty issue with this drug. Drug loaded transferosomal vesicles were prepared with phospholipon 90G (PC 90G) as structural phospholipid and sodium deoxycholate (SDC) as edge activator/surfactant by conventional thin-layer rotary evaporation method [4]. Response surface methodology (RSM) was applied for the optimization of formulation using Box-Behnken experimental design. Phospholipid PC90G (A), SDC (B) and sonication time (C), each at three levels, were selected as independent variables while entrapment efficiency (EE%) (Y1), vesicle size (Y2), and transdermal flux (Y3) were the response variables. In-vitro release and permeation of raloxifene from the transfersomal formulations were measured by Hanson diffusion cell using rat skin as barrier membrane. Amount of drug present in test samples during entrapment efficiency and in-vitro permeation study was determined by a validated HPLC method. Seventeen (17) trial formulations at various factors combinations including five centre points were prepared according to the Box-Behnken experimental design as shown in Table 1. Various RSM computations were performed by Design expert® software (version 8.0.7.1, stat-Ease Inc., Minneapolis, MN). Polynomial models including interaction and quadratic terms were generated for all response variables using multiple linear regression analysis (MLRA) approach. Response surface graphs (3-D) and two dimensional (2-D) contour plots were generated in order to evaluate the effects of individual independent variables on response variables. The optimized formulation as predicted by RSM was then further characterized for vesicular size distribution, shape, surface morphology, and zeta-potential. Conventional liposomes consisting of raloxifene were also prepared by mechanical dispersion to compare transdermal flux with that of transfersomes [5]. Coumarin-6 (0.03% w/v) loaded transfersomes and liposomes were prepared for confocal laser scanning microscopy (CLSM) study. Six-point standard curve in the range of 0.125 to 5 µg/ml by HPLC was found to be linear with correlation coefficient 0.999 (calibration equation y = 76.082x + 8.466). Representative chromatogram of a sample analysed for in-vitro drug permeation study is shown in Fig. 1. TEM, DLS defined transfersomes as spherical, unilamellar structures with a homogenous distribution and low polydespersity index (PDI) (0.080±0.021). Visualization of transfersomes by SEM also proved the same finding (Fig. 2). The results of entrapment efficiency (EE%) (Y1), vesicle size (Y2), and transdermal flux (Y3) are presented in Table 1. After analyzing the response variables data by Design expert® software, the best model for all three response variables was found to be quadratic. Mathematical relationship generated using MLRA for the studied response variables are expressed as following equation 1 to 3. Y1 = +84.93 + 4.50A - 2.25B - 0.50C -3.25AB - 0.25AC - 0.25BC + 0.91A2 - 7.59B2 - 0.59C2 (eqn. 1) Y2 = +149.80 + 21.88A – 19.12B – 6.00C – 10.25AB – 4.50AC + 8.00BC – 32.28A2 + 11.73B2 – 10.02C2 (eqn. 2) Y3 = +4.10 + 1.08A – 0.37B – 0.075C – 0.25AB – 0.20AC – 0.20BC + 0.25A2 – 1.40B2 +0.50C2 (eqn. 3) Effects of three independent variables on each of the response variables were found to be highly significant according to 2D-contour plots in Fig 3. Point prediction method of the Design Expert software® was utilized to select the optimized formulation based on the criteria of attaining the maximum value of entrapment efficiency (EE %) and transdermal flux while minimum value of vesicle size. Formulation No 13 with composition of 300mg PC90G (A), 35mg SDC (B) and 15min sonication time (C) was predicted as an optimized formulation. Optimized formulation resulted a particle size of 134±9.0 nm with 91±4.9% EE% and 6.5±1.1µg/cm2/h transdermal flux. Raloxifene HCl loaded transfersomal formulation proved significantly superior in terms of amount of drug permeated and deposited in the skin, with and enhancement ratio of 6.25±1.5 and 9.25±2.4 when compared with conventional liposomes and ethanolic PBS. DSC study was revealed a greater change in skin structure for transfersomal formulation as compared to control sample during in-vitro permeation study (Fig. 4). Further, confocal scanning laser microscopy (CSLM) proved an enhanced permeation of coumarin-6 loaded transfersomes to the deeper layers of the skin (160 µm) as compared to the rigid liposomes (60 µm) (Fig.5). These in-vitro findings proved that Raloxifene HCl loaded transfersomes formulation could be a superior alternative to oral delivery of the drug.

Item Type:	Conference or Workshop Item (Poster)
Additional Information:	5209/38278
Uncontrolled Keywords:	Raloxifene, transfersomes, formulation, response surface methodology (RSM), optimization
Subjects:	R Medicine > RS Pharmacy and materia medica
Kulliyyahs/Centres/Divisions/Institutes (Can select more than one option. Press CONTROL button):	Kulliyyah of Pharmacy > Department of Pharmaceutical Technology
Depositing User:	Dr Muhammad Taher
Date Deposited:	18 Sep 2014 11:11
Last Modified:	11 Jun 2018 13:55
URI:	http://irep.iium.edu.my/id/eprint/38278

Actions (login required)

View Item